Silencer Guard Assembly

1.Remove silencer guard and two screws from the owner’s kit.

2.Attach the silencer guard to the rear housing.

NOTE: Make sure the bent end of the silencer guard fits securely into the opening of the rear housing.

3.Using the torque wrench supplied, install the two screws and tighten securely.

REAR HOUSING

TORQUE

WRENCH

SCREWS

SILENCER

GUARD

BENT END OF

SILENCER GUARD

OPENING IN REAR

HOUSING

Fig. 4

Image 8

Contents

OPERATOR’S Manual Table of Contents Safety Specific Safety Rules for Trimmer USE Symbols Symbol Name Explanation Technical Data 13.3 Features UnpackingInstructions Packing List for OWNER’S KIT See Figure AssemblyAssembly Instructions Silencer Guard Assembly Operating the Trimmer OperationFuel and Refuelling Advancing String Using the EZ Line TAP Advance System Advancing the StringCutting Tips Grass Deflector Line Trimming CUT-OFF Blade Starting and Stopping To Start a Cold EngineTo Start a Warm Engine To Stop the Engine Maintenance Spool Replacement EZ Line TAP Advance SystemNEW PRE-WOUND Spool See Figures 10 Cleaning the Exhaust Port and Silencer String ReplacementSpark Arrester Arrows on Spool Anchor Hole First String Replacing and Cleaning AIR Filter Fuel CAPSparking Plug Storage 1 Month or Longer Troubleshooting Dealer. See Figure Idle Speed Screw LO Needle High Needle Warranty Safety DirectiveGuarantee Statement Rtsa / Rtuk / RTG Sound Pressure Sound Power Vibration Model Model no Ryobi Technologies GmbH