:
assembly
2. Securely clamp board to workbench using
"C" clamps.
NOTE: Supporting surface where band saw is
mounted should be examined carefully after
mounting to insure that no movement during use
can result. lf any tipping or walking is noted,
secure workbench or supporting surface before
operating band saw.
CLAMPING BANDSAW TO WORKBENCH
The Band Saw can be clamped direcily to a
workbench using two (2) or more "C" clamps on
base of unit. WORKBENCH
INSTALLING THE TABLE
Apply a coat of automobile wax to the table too
and inside surfaces of trunnion that slide on
frame.
1. Loosen the guide bar lock knob and position
the upper guide assembly all of the way up.
Tighten lock knob.
UPPER
GUIDE
ASSE I\4 BLY
\12
2.
3.
Locate two (2) knobs and two (2\ 17164 x
47164 x 1/16 washers in loose parts bag, and
the table assembly in loose parts.
Place table assembly onto band saw frame
with thd trunnion against mounting rib in
frame.
TRUNNION
-
STOTS
4. Hold table
install two
as shown
tighten.
assembly against the frame and
(2) taOle lock knobs and washers
through the trunnion slots and
2