DRIVE BELT TENSION
WARNING: TO AVOID INJURY DUE TO ACCI.
DENTAL START, UNPLUG TOOL BEFORE
MAKING ADJUSTMENTS.
The tension on the drive belt has been set at the
factory. lf adjustment is needed, use a 3/16" hex
wrench to loosen upper and lower cap screws.
Pull motor away f rom drive wheel to apply proper
tension to drive belt. Retighten cap screw while
holding motor in place.
DRIVE BELT
I
i
I
l-
ADJUSTING THE TABLE
1. Replace the blade guard on the upper assem-
bly and tighten screws,
2. Locate the table insert and place it in the
opening in the table A rgn slot in the insert
with the slot in the table
3. Locate a 114 -20 x 3 4" truss head screw, a
flat washer. a^c a 1 4 - 20 wing nut in loose
parts. Insert s..e..' nto hole in table top as
illustrated
4. From the undersrde of the table, install wash-
er and ,^, "_c ^;: onto the truss head screw
and trghte" rrrger tight. This will keep the
table f lat ano rn alignment.
5 Reo ace 1^e card saw cover.
TRUSS HEAD
SCREW
WASHER
WI NGN U]
TAEtE
INSERI
---7
^
getting to know your band saw
1
1]JUS-IING'KNOB
5
GUIDE BAR
LOCK KNOB
TABTE
IRACKING ADJUST[/ENT
BTADE
TABL E
FRONT 13