ITEM TABLE OF LOOSE PARTS OTY.
A
B
c
D
Basic saw assembly
Owners Manual
Saw Table assembly
Bag Assembly Part #69181
Containing the following parts:
Switch, Key ..
Nut, Wing 114-20.
Screw, Truss Hd. 114-20 x 314. .
Washer 17164 x5/8 x 1/16 . ....
Washer 17164 x 47164 x 1/16 . . .
Indicator, Bevel .
Screw, Pan Cross 10-24 x 114. .
Insert, Table
Knob .
1
1
1
I
1
't
1
2
1
1
1
a
\t --a12=
assembly
MOUNTING BAND SAW TO WORKBENCH
lf band saw is to be used in a permanent loca-
tion, it should be f astened securely to a f irm sup-
porting surface such as a workbench.
lf mounting to a',^',orkbench. holes should be
drilled tirougf'sucJorrr"r g surface of the work-
bench usino dimenstons lustrated.
Each leg shou I be bolted securely using
5/16 " drameter machlne screws, lockwashers,
and 5/16' hex n uts lnot included). Screl.r
length shou C be l': " plus the thickness of
the bench toc
Locate and r',arK the holes where band saw is
to be mounted.
3. Drill (4) 3,8 drameter holes through work-
oencn.
Place band saw on workbench aligning holes
in feet with holes drilled in workbench.
Insert ali four 5'l6" screws and tiohten.
NOTE: Front two mounting bolts
inserted from the bottom with washer
rop.
shou ld
and nut oe
on
6-5/16"
I
I
+
I.-
3/8" DIA[IETER
(4)HOLES
f
10-r3/16"+l
4.
An alternate method of mounting is to fasten
band saw to a mounting board. The board should
be of suff icient size to avoid tipping of saw while
in use. Any good grade of plywood or chipboard
with a 3/4" minimum thickness is recommended.
(Thinner chipboard can break.)
1. Follow instructions for mounting to work-
bench, substituting a board 18" x 24" mini-
mum size and using 5/16 inch flat head
screws, lockwashers, and hex nuts (not in-
cluded). Screw length should be 11/2 " plus
the thickness of the mountino board.
NOTE: For proper stability, holes must
counter sunk so screw heads are flush with
bottom surface of supporting board.
24 " iIlN
-t be
the
Tf
I
6-5i16" //+
3/8" D]AN4EIER (4) HOTES
I
++
l..-to-r3/ro"+l
18" N4IN