Ryobi Outdoor RY52001, RY52001A manual Limbing and Pruning, Operating the Trimmer, See Figures 8

OPERATION

LIMBING AND PRUNING

See Figures 8 - 9.

This unit is designed for trimming small branches and limbs up to 6 in. in diameter. For best results, observe the follow- ing precautions.

nPlan the cut carefully. Be aware of the direction in which the branch will fall.

nBranches may fall in unexpected directions. Do not stand directly under the branch being cut.

nThe most typical cutting application is to position the unit at an angle of 60° or less, depending on the specific situ- ation, as shown below. As the angle of the pruner shaft to ground increases, the difficulty of making the first cut (from the underside of limb) increases.

�n Remove long branches in several stages.

�n Cut lower branches first to allow the top branches more room to fall.

60° MAXIMUM

Fig. 8

nWork slowly, keeping both hands on the saw with a firm grip. Maintain secure footing and balance.

nKeep the tree between you and the chain while limbing. Cut from side of tree opposite branch you are cutting.

�n Do not cut from a ladder; this is extremely dangerous. Leave this operation for professionals.

�n Do not to make the flush cut next to the main limb or trunk until you have cut off the limb further out to reduce the weight. Following proper cutting procedures will prevent stripping the bark from the main member.

�n Do not use the pruner for felling or bucking.

�n To prevent electrocution, do not operate within 50 ft. of overhead electrical lines.

�n Keep bystanders at least 50 ft. away.

Fig. 9

OPERATING THE TRIMMER

See Figure 10.

WARNING:

Always position the unit on the operator’s right side. The use of the unit on the operator’s left side will expose the user to hot surfaces and can result in possible burn injury.

WARNING:

To avoid burns from hot surfaces, never operate unit with the bottom of the engine above waist level.

Hold the trimmer with your right hand on the rear handle and your left hand on the front handle. Keep a firm grip with both hands while in operation. Trimmer should be held at a comfortable position with the rear handle about hip height.

PROPER

OPERATING POSITION

Fig. 10

12