ADJUSTMENTS
WARNING:
To prevent accidental starting that could cause serious personal injury, always disconnect the spark plug wire when making adjustments.
ADJUSTING WHEEL POSITION
See Figures 15 - 17.
The wheel position of the unit is adjustable. Holes on the wheel support rod offer different heights to choose from in both the A and B positions.
n Install the wheel assembly accessory in position A to transport the cultivator to and from the work area.
n For general cultivating, remove the wheel assembly to al- low deep penetration of the tine blades into the cultivating surface.
n The wheel assembly accessory may be installed in posi- tion B to allow use of the drag bar during cultivating.
ADJUSTING DRAG BAR POSITION
See Figure 18.
The drag bar may be used to help control the cultivator’s speed and depth of operation. It is located in a slot on the wheel assembly support and is secured with a pull pin.
To adjust the height of the drag bar: n Remove the pull pin.
n Shift the drag bar up or down, depending on the depth you are trying to achieve.
n Reinsert the pull pin through the wheel support and drag bar to secure.
PULL PIN
WHEEL
SUPPORT
POSITION A
Fig. 15
WHEEL ASSEMBLY
ACCESSORY
REMOVED
FOR GENERAL
CULTIVATING
Fig. 16
WHEEL
SUPPORT
POSITION B
Fig. 17
DRAG
BAR
Fig. 18
14
