Saeco Coffee Makers 104342 manual Rinse/Self-cleaning Cycle, To the position

Steady on

Using the machine for the first time or after a long period of inactivity.

These simple operations will make it pos- sible to always brew excellent coffee.

1Place a large container under the dispensing spout.

2Before starting the procedure, check

that the following icon is displayed and that the buttons “” and “” on the control panel are steady on.

3Select the pre-ground coffee function by pressing the “ “ button one or more times.

Do not add the pre-ground coffee to the compartment.

9	Dispense water until the no water si-
	gnal is displayed, then turn the selec-
	tor switch counter-clockwise to set it
Steady on	to the “ ”position.
10	At the end, fill the water tank again.	English
	Then the products can be brewed as
	described in the following sections.

Steady on

The icon will appear on the display.

4Press the button to brew a long cof- fee.

5Wait until brewing is completed and empty the container.

6Repeat the operations from step 1 to step 5 for 3 times; then continue with step 7.

7Place a container under the steam wand (Pannarello, if supplied).

8Turn the selector switch clockwise to set it to the “”position.

Blinking

Rinse/Self-cleaning Cycle

This cycle allow rinsing the coffee circuits with fresh water.

The cycle is carried out:

•At machine start (with cold boiler)

•After priming the water circuit (with cold boiler)

•During the Stand-by preparation phase (if a coffee product has been brewed)

•During the phase of activating the stand-by mode after pressing the “STAND-BY”button (if a coffee product has been brewed).

A small amount of water will be dispen- sed, which will rinse and heat all the ma- chine components; in this phase the but- tons “”and “”blink alternately.

Wait for the cycle to fi nish automatically.

You can stop dispensing by pressing either of the two brew buttons.

• 9 •