Saitek TM A-350 manual Switching To A Line Source, Battery Life, Troubleshooting

dmeQSGA350.qxd 11/2/2005 12:40 PM Page 6

SWITCHING TO A LINE SOURCE

To switch from the wireless transmitter to 3.5mm Line-in as audio source, connect the headphones to your audio source with the 3.5mm jackplug cable. Press and hold 'Vol -' for 5 seconds.The LED will then light up blue for 2 seconds then go off to show that the connection has now switched to Line-in.

Default audio source on Power On is 'Wireless Audio Streaming'.

To revert back to wireless audio streaming mode, Press and hold 'Vol -' for 5 seconds.The unit will then re-establish a wireless connection with the transmitter. The volume will also return to the previous level after the audio source is changed.

Please note:You can only switch to a Line-in source if there is still power left in the battery. If there is insufficient power, recharge the headphones.

BATTERY LIFE

In normal use, your wireless headphones should give 6hrs playing time on one recharge.

To save battery life or when the batteries require recharging, simply connect your headphones to the music source using the 3.5mm jack cable provided.

TROUBLESHOOTING

My MP3 player is playing music, but I cannot hear any sound from my headphones. Check that the headphones' volume is not at 0. Press the volume up button to increase volume until you can hear the music.

Check that the wireless transmitter's jackplug is properly inserted in your music player's audio socket.

Check that your music player’s volume control is not at “0”. If it is, increase it. Check that the batteries have not run out. If the LED on either the headphones or transmitter is red or not lit up at all, recharge either or both units.

Check that there is a wireless connection between the transmitter and headphones unit.

To improve the signal range:

Allow as much free space as possible between the transmitter and receiver, and avoid placing dense or metal objects between them.

As the headphones antenna is on the left side of the unit, try to place the wireless transmitter on your left side to improve the connection.

If the signal is lost the two units will take a few seconds to re-establish a connection.