Guided Tour - Servo-550 Rear Panel
1 |
|
|
| 2 | |
10A/250V |
|
|
| SERVO 550 STUDIO AMPLIFIER | |
FUSE |
|
|
|
| |
|
| CAUTION; REPLACE |
|
| |
|
| WITH THE SAME TYPE |
|
| |
|
| FUSE AS INDICATED. |
|
| |
E | F | UTILISER UN FUSIBLE | S/N |
| |
| SU | DE RECHANGE DE |
|
| |
|
| MEME TYPE. |
|
|
|
USE CLASS 2 WIRING MAXIMUM LOAD IMPEDANCE 4Ω | |||||
BRIDGED MONO 8Ω | - |
| + |
| |
| GROUND | +RIGHT | LEFT + | GROUND | |
|
| OUTPUT 275W/4Ω |
|
| |
| CAUTION | ! |
| CAUTION | |
RISK OF ELECTRIC SHOCK |
| HEATSINK MAY BE HOT! | |||
| DO NOT BLOCK AIRFLOW | ||||
| DO NOT OPEN |
| |||
|
| OR | |||
|
|
|
|
| OCCUR |
TO PREVENT SHOCK DO NOT OPEN. NO USER |
|
|
| ||
SERVICABLE PARTS INSIDE. REFER SERVICING |
|
|
| ||
TO QUALIFIED SERVICE PERSONNEL.TO |
|
|
| ||
PREVENT FIRE OR SHOCK HAZARD DO NOT |
|
|
| ||
EXPOSE TO RAIN OR MOISTURE. |
|
|
| ||
RIGHT | LEFT |
| ~AC INPUT |
115V/60Hz,1080W
6
SAMSON
STEREO
BRIDGED
MONO
| LEFT | 7 |
| RIGHT |
|
INPUTS |
| |
(BALANCED |
| |
10KΩ /0dBu) |
| |
TIP RING SLEEVE |
| |
TIP | + |
|
RING | - |
|
SLEEVE GND |
|
3
4
5
1:Fuse holder - Insert a 10 amp, 250 volt fuse here for 115 volt operation, or a 5 amp, 250 volt fuse for 230 volt operation. We recommend the use of normal (as opposed to
2:Binding post (banana jack) output connectors (left/right) - Use these to connect the
3:1/4" Unbalanced output connectors (left/right) - Alternatively, these can be used to connect the
4:AC input - Connect the supplied standard
5:Heat sink - Make sure this anodized aluminum heat sink is unobstructed when the amplifier is powered on. In particular, when the
6:Bridged Mono/Stereo switch - For normal stereo operation, place this switch at its up (“Stereo”) position. To bridge the two amplifier sections for mono usage (with full 550 watt power output), place this switch at its down (“Bridged Mono”) position. For more information, see Appendix E on page 13 in this manual. WARNING: Due to the extremely high power output of the
8 ohm loudspeakers rated to handle 550 watts of power or greater.
7:Inputs (left/right) - Connect incoming signal to these electronically balanced 1/4" TRS (Tip/Ring/Sleeve) jacks, wired as follows: Tip hot, Ring cold, and Sleeve ground. The
6