Operating the C•que 8
STEREO AND TWO-CHANNEL MODES
All of the C•que 8’s four channels can be set to operate in two different modes: Stereo and 2 Channel.
Stereo Mode
Stereo mode is a normal operating mode where all mix inputs from MAIN and INJECT, maintain their stereo image throughout the signal path to each headphone output. The BALANCE control is used to adjust the stereo image between the Left and Right side. To design a monitor mix in the Stereo mode, follow these steps:
•Press the ST/2CH switch to the OUT position. You’ll notice the switch LED is not illuminated indicating that the main input is in STEREO mode.
•Make a Stereo connection from your mixer’s auxiliary or bus outputs to the main Left and Right Line inputs on the C•que 8’s rear panel.
•In the Stereo mode, the BALANCE control adjusts the loudness between the left and right headphone outputs.
Mixing Signals in 2-Channel Mode
In
•Press the ST/2CH switch to the IN position. You’ll notice the switch LED is now illuminated indicating that the C•que 8 is in
•Create a mono monitor mix on one of your mixer’s auxiliary sends and make a connection from that aux send output to the MAIN Left input on the C•que 8’s rear panel.
•Use your mixer’s direct output, or another aux send, to route the signal of the lead vocal channel and make a connection from that output to the C•que 8’s MAIN Right input.
MAIN
OL
0
0 | 10 L | R |
VOLUME BALANCE
INJECT
2 CH STEREO
•Now, you can use the BALANCE control to adjust the level difference between the monitor mix and the vocal channel. By using a combination of the MAIN VOLUME and BAL- ANCE controls you can dial up the perfect mix directly on the C que 8.
9