Contents
EX10 EX20 EX30
Expedition Accessories Specifications
Table of Contents Introduction System Features
EX10 EX20 EX30
Positioning and Mounting Instructions
Introduction
System Features
which allows any Expedition enclosure to
System Features
Interconnecting the EX10
Speakon Wiring
Expedition EX10
Guided Tour
Expedition EX10
Using two EX10s in mono A single mono signal bus or aux send is routed from a mixer to a power amplifier. One speaker output of the power amplifier is connected to either the EX10 1/4 input solid line or Speakon input dotted line, and a connection is made between either the 1/4 extension to a second EX10’s input solid line or between the Speakon extension to a second EX10’s Speakon input dotted line
Interconnecting the EX20
Expedition EX20
Guided Tour
Expedition EX20
Using two EX20s in mono A single mono signal bus or aux send is routed from a mixer to one EX20’s XLR input, and a connection is made between that EX20’s XLR output to a second EX10’s XLR input
Guided Tour
Expedition EX30
Expedition EX30
5 Insert sub connector - This 1/4 connector brings line-levelsignal in directly before the EX30 power amplifiers. It is normally used to return signal from an optional EX500 subwoofer
Expedition EX30
Interconnecting the EX30
Expedition EX30
Using one EX30 and an EX20 stereo operation In this example, microphones are connected to the XLR mic inputs of channels 1 and 2 of an EX30, and a stereo keyboard is connected to the stereo 1/4 TRS connector of channel 3/4 of the EX30 using a Y-cord,with the tip carrying the left signal and the ring carrying the right signal. A connection is then made between the Right output of the EX30 to the XLR input of an EX20. IMPORTANT NOTE When using the EX30 with additional Expedition enclosures, always be sure to set the EX30 Mono/Stereo switch to “Stereo.”
General Positioning Tips
Positioning and Mounting Instructions
Pole-Mounting
Fly Mounting, Wall Mounting, and Ceiling Mounting
Positioning and Mounting Instructions
Before fly-mounting, wall-mountingor ceiling-mountingthe Expedition, you must first install a Samson MP 1030 mounting bracket to the fly points, as shown in the illustrations on the right
Expedition Accessories
Guided Tour TD30
SOFT EJECT
Dimensions all models
Specifications
Weight
Frequency Response all models
