Samson MDR624 12POWER LED, 13- Phantom Power LED, Output Level Meter, Auxiliary Return, AUX RET

Controls and Functions

MASTER SECTION - continued

12POWER LED

The Power LED lights up to indicate that the main POWER switch (located on the rear panel) is on.

13- Phantom Power LED

	This LED illuminates indicating that the 48 volt
	phantom power is applied to the microphone	HF		2T IN	2T OUT
	pre-amps enabling use with condenser micro-
		12K
	phones. The +48V LED will light up when the	10	LEFT			LEFT
	Phantom Power switch (located on the rear
	panel) is switched to the ON position.
14		MF	RIGHT			RIGHT
	Output Level Meter	2.5K
		10
					13	12
	The OUTPUT LEVEL METER allows you to		5
			AUX RETURN
	monitor the level of the signal which is being	LF
	sent to the MIX OUT jacks.				PHANTOM	POWER
		80Hz	15
		10
	NOTE: To avoid distortion, adjust the Main Level		0	10
	control so that the 0 indicator LED lights occa-				CLIP
	sionally.				+12
		AUX	2TK TO MIX		+6
	Auxiliary Return
					0
	The MDR624 has a stereo auxiliary return,				-6
					-12
	which can be accessed via the pair of 1/4-inch
			2TK TO C/R		-18
	phone jacks located on the top panel. The
		BAL			-24
	Auxiliary Return can be used to connect any
					L	R
	stereo line level signal, but they are primarily
					OUTPUT LEVEL
	used to connect the output of external effects				14
	processors.
			5		5
		EAK
15	AUX RET
	This adjusts the amount of signal that is com-		0	10	0	10
			LEVEL		LEVEL
	ing from the AUX RET jacks to the MAIN bus.
	For more information on using the AUX control see		CR / PHONES		MAIN LEVEL
	the section “USING AN EXTERNAL EFFECT” on page
	13 of this manual.

9