Front and Rear Panel Layout

Front and Rear Panel Layout

FRONT PANEL

1MIC – Input connector for Low-Noise Microphone pre- amp.

2LINE –Input connector for Line level inputs.

3GAIN – Used to set the input level of the mic pre and line input.

4HIGH FREQUENCY – Controls the high band of the Channel Equalizer, +/- 15 dB at 12KHz.

5MID FREQUENCY – Controls the mid band of the Channel Equalizer, +/- 15 dB at 2.5KHz.

6LOW FREQUENCY – Controls the low band of the Channel Equalizer, +/- 15 dB at 80Hz.

7AUX – Pre fader auxiliary send that can be used with an external effects processor, or to create a cue or monitor mix.

8PAN – Controls the channel’s position between left and right in the stereo bus.

9PEAK – Red LED will illuminate indicating when the GAIN has been adjusted too high.

10LEVEL – Audio taper fader provides smooth control over level changes.

11RIGHT LINE 1/4-inch phone input connector for the right line input for the stereo channels.

12LEFT LINE - 1/4-inch phone input connector for the Left Line input for the stereo channels.

13AUX RET – Input connector from external line level

182 TRACK INPUTS – Connect the output from a DAT, Cassette, Mini Disk or Hard Disk Recording system.

192 TRACK OUTPUTS – Connect to the input of a DAT, Cassette, Mini Disk or Hard Disk Recording system.

20AUX RETURN – Used to mix in level of the effects return.

21PHANTOM – Indicates that the 48 Volt Phantom Power is on.

22POWER – Indicates the MDR624 is powered up.

23OUTPUT METER - Eight segment display with VU ballistics indicates main Mix level.

242 TRACK TO MIX - Switch used to mix the 2 track input with the mix from the channel inputs.

252 TRACK TO CR – Switches between the main Mix and the 2 Track in the Control Room output.

26MAIN LEVEL – Used to control the overall volume of the Left and Right main Mix outputs.

27C ROOM/HEADPHONE – Adjusts the volume of the control room speakers or headphones.

28BALANCE – Controls the channel’s position between left and right in the stereo inputs.

REAR PANEL

sources.

14AUX SEND – Line level output from the Auxiliary bus.

15HEADPHONE JACK – Connect stereo headphones here.

16CR OUTPUT– Left and Right Control Room output connec- tors for connecting a monitor system.

17MIX OUTPUT – Left and Right main Mix output connec- tors.

APOWER – Switches on the MDR624’s main power.

BPHANTOM – Engages the 48-Volt Phantom power supply to microphone pre-amps.

CAC ADAPTOR INLET – Connect External AC power supply here.

5