Manuals / Samson / Home Audio / Speaker

Samson Sub120 owner manual SUB120 Connections, SUB120 Wiring Guide, Negitive

Models: Sub120

1 18

Download 18 pages 46.55 Kb

Page 16

Image 16

SUB120 Connections

SUB120 Wiring Guide

There are several ways to interface the SUB120 depending on your exact monitoring set-up. The SUB120 fea- tures both Preamp Level and Speaker Level inputs and outputs, so connecting to any active or passive satellites speakers is easy. Follow the cable diagrams below for connecting your monitor system.

Speaker Cable (Un-Shielded)

Positive

Negitive

Note: Just about all un-shielded speaker wire will have a marking indicating the negative side. To avoid phase cancelation problems, be sure to maintain the correct connection for the positive and negative sides throughout your system.

Unbalanced 1/4” to RCA Cable

Tip (signal)

Sleeve (ground)

Tip (signal)

Sleeve (ground)

Un-Balanced XLR to RCA Cable

Hot (2) Common (1)

1	2	2	1
	3		3
End View		Solder Points

Cold (3)

Male XLR

Tip (signal)

Cold (Pin 3)

(no connection)

Sleeve (ground)

Tip (signal)

Sleeve (ground)

Page 16

Image 16

Samson Sub120 owner manual SUB120 Connections, SUB120 Wiring Guide, Negitive

Contents

S U B 1 2 S U B W O O F E ROWNERS MANUAL R E F E R E N C ESafety Instructions AVISSUB120 Features Setting Up the SUB120Connecting the Sub120 SUB120 Wiring GuideIntroduction SUB 120 Features SUB 120 Layout Front View Layout2ENCLOSURE - Rigid MDF Construction 3FINISH - Sleek black oak finishSUB 120 Layout Rear Panel LayoutSAMSON Setting up the SUB120 CONFIGURING YOUR SPEAKER SYSTEMOperating the SUB120 Common Sub Operation1 Volume Control 3 Power/Protect LED4Auto On Switch 5Phase SwitchConnecting the SUB120 Using The DMS80’s SUB OUTConnecting the SUB120 The SUB120 can be connected to the DMS80’s by using the LINE OUTS located on the DMS80’s rear panel. When using the DMS80’s LINE outputs you will utilize the SUB120 internal electronic crossover, which will allow you to experiment and fine-tuneyour monitor system. Follow the diagram and instructions below to interface your new subwooferConnecting the SUB120 FROM MIXERConnecting the SUB120 The SUB120 can be operated using line level inputs and outputs. When using the SUB120 at line level, the full range signal is maintained at the outputs. Below is a typical system set up using the SUB120 with a mixer, stereo power amp and a pair of passive satellite loudspeakers. The SUB120’s inputs and outputs utilize industry stan- dard RCA connectors. For a detailed wiring diagram, see the section SUB120 Connections on page 17. Follow the steps below the diagram to set up your systemMono Sub With Active Satellites Connecting the SUB120Stereo Sub With Passive Satellites Connecting the SUB120SUB120 Connections SUB120 Wiring GuideNegitive Sub 120 Frequency Chart SpecificationsSpecifications Samson Technologies Corp 575 Underhill Blvd P.O. Box Syosset, NY Phone: 1-800-3-SAMSON Fax: