Guided Tour - UR1 Rear Panel
1
2
3
4
ENGLISH
AC CABLE LOCK
DC INPUT | UNBALANCED |
| OUTPUT |
+ -
CAUTION:
USE SAMSON
AC ADAPTOR
ONLY
CABLE LOCK: LOOP THRU AND TIE
BALANCED SWITCH | BALANCED OUTPUT | |
LINE: |
| |
| ||
MIC: |
| |
XLR: | ||
MIC LINE | ||
1 GND | ||
| 2 HOT | |
POWER RATING | 3 COLD | |
| ||
DC 12V, 1.9W(160mA) |
|
1:DC input - Connect the supplied 12 volt 160 mA power adapter here, using the strain relief as shown in the illustration below. WARNING: Do not substitute any other kind of power adapter; doing so can cause severe damage to the UR1 and will void your warranty.
-
Using the strain relief: Gather up a loop of wire and pass it through the strain relief, then pass the adapter plug through the loop in order to create a knot.
2:Unbalanced output* - Use this unbalanced high impedance (5K Ohm) 1/4" jack when connecting the UR1 to consumer
3:Audio Output Level switch - Sets the audio output level attenuation of the balanced output (see #4 below) to
4:Balanced output* - Use this electronically balanced low impedance (600 Ohm) XLR jack when connecting the UR1 to professional (+4) audio equipment. Pin wiring is as follows: Pin 1 ground, Pin 2 high (hot), and Pin 3 low (cold).
*If required, both the unbalanced and balanced outputs can be used simultaneously.
UHF Series One Frequency Conversion Chart
Channel | Frequency |
U1 | 801.375 MHz |
U2 | 801.875 MHz |
U3 | 803.125 MHz |
U4 | 803.750 MHz |
U5 | 804.500 MHz |
U6 | 804.750 MHz |
6