Spinpoint M8-DVR OEM Product Manual REV 1.0
61
Table 8-10 Identifier and security level bit interac tion
Identifier
Level
Command
result
User
High
The password supplied with the command shall be saved as the
new User passwo rd. The Lock mode shall be enabled f rom
the next power-on or hardware reset. The device shall then be
unlocked by either the User password or the previously set Master
password.
User
Medium
The password supplied with the command shall be saved as the
new User passwo rd. The Lock mode shall be enabled f rom
the next power-on or hardware reset. The device shall then be
unlocked by only the User password. The Master password
previously set is still sto red in the device but shall not be used to
unlock the device.
Master
High or
Medium Maximum This combination shall set a Master password but shall
not enable or disable the Lock mode. The security level is not
changed. Master password revision code set to the value in Master
Password Revision Code field.

8.2.27 Security Unlock (F2h)

This command transfers 512 bytes of data from the host. If the Identifier bit is set to Master and the device
is in high security l evel, then the password supplied shall be compared with the stored Master password. If
the device is in maximum security level then the unlock shall be rejected.
If the Identifier bit is set to the user then the device needs to co mpare the supplied password with the stored
User password.
If the password compare fails then the device shall return command aborted to the host and decrements the
unlock counter. This counter shall be initially set to five and shall be d ecremented for each p assword
mismatch when SECURITY UNLOCK is issued and the device is locked. When this counter reaches zero
then SECURITY UNLOCK and SECURITY ERASE UNIT commands shall be command aborted until a
power-on reset or a hardware reset. SECURITY UNLOCK commands issued when the device is unlocked
have no effect on the unlock counter.

8.2.28 Seek (7xh)

This command has become obsolete in the ATA7 specification. The supporting of this command is just for
backward compatibility purpose.

8.2.29 Set Features (EFh)

This command is used by the host to establish the following parameters, which affect the execution of certain
drive features as shown below.