Samsung AQ09TSBN, AQ09TSBNCEE, AQ09TSBNSER, AQ09TSBX, AQ09TSBXCEE, AQ09TSBXSER, AQ09UGEN, AQ09UGFN, AQ09UGFNEUR, AQ09UGFX, AQ09UGFXEUR, AQ12TSBN, AQ12TSBNCEE, AQ12TSBNEUR, AQ12TSBNSER, AQ12TSBX, AQ12TSBXCEE, AQ12TSBXEUR, AQ12TSBXSER, AQ12UGEN, AQ12UGFN, AQ12UGFNEUR, AQ12UGFX, AQ12UGFXEUR, AQ18TSBN, AQ18TSBNCEE, AQ18TSBNEUR, AQ18TSBX, AQ18TSBXCEE, AQ18TSBXEUR, AQ18UGAN, AQ18UGANEUR, AQ18UGAX, AQ18UGAXEUR, AQ18UGEN, AQ18UGFN, AQ18UGFNEUR, AQ18UGFX, AQ18UGFXEUR, AQ24TSBN, AQ24TSBNCEE, AQ24TSBNEUR, AQ24TSBX, AQ24TSBXCEE, AQ24TSBXEUR, AQ24UGEN, AQ24UGFN, AQ24UGFNEUR Memo

Memo

ENGLISH

Boracay EUR_AQ09T&U@_IBIM_32447A_E.indd 41			2011-3-19 10:08:25
Boracay EUR_AQ09T&U@_IBIM_32447A_E.indd 41			2011-3-19 10:08:25

Contents

Page Contents Page Page Page Checking before use Checking the name of the parts Checking the remote controller Remote controller display Operation mode Turbo indicator indicator Quiet indicator Basic function button to adjust the temperature Adjusting the air flow direction Using theTurbo function mode Setting the On/Off timer Using the Smart Saver function Using the Auto Clean function Cleaning the air conditioner Page Maintaining the air conditioner Troubleshooting Error is indicated Noise is generated the outdoor unit Water is dropping from the outdoor unit piping Included Models Remark Choosing the installation location Page Page Accessories Fixing the installation plate Connecting the assembly cable 2 . Open the front grille 3 . Remove the screw securing the connector cover 5 . Pass the other end of the cable through the 65mm hole in the wall 6 . Close the connector cover by tightening the screw carefully 7 . Close the front grille 2.Smooth the cut edges 4.Cut off the remaining foam insulation Outer Diameter 6.Pass the pipe through the hole in the wall Purging the indoor unit Cutting or extending the pipe Installing and connecting the drain hose of the indoor unit Drain hose installation 1.If necessary, connect the 2-meterextension drain hose to the drain hose tight downwards as seen in the picture 1.Detach the rubber cap with the plier Purging the connected pipes gas service port as seen in the picture Mount the valve stem nuts and the service port cap to the valve, and tighten them at the torque of 183kgf•cm with a torque wrench Check for a gas leak paying particular attention to the 3-wayvalve’s stem nuts and to the service port cap (Refer to page 37) Page Performing the gas leak tests Fixing the indoor unit in place Fixing the outdoor unit in place Outdoor unit installed on the wall by rack Final Check andTrial Operation How to connect your extended power cables Memo COUNTRY CALL OR VISIT US ONLINE AT