Alen MDF-70AE, MDF1-30AE, MDF-50AE Operating The Unit, Positioning the unit, When using the unit

Models: MDF-50AE MDF-70AE MDF1-30AE

1 12
Download 12 pages 39.76 Kb
Page 7
Image 7
OPERATING THE UNIT

OPERATING THE UNIT

Positioning the unit

A dehumidifier operating in a basement will have little or no effect in drying an adjacent enclosed storage area, such as a closet, unless there is adequate circulation of air in and out of the area.

Do not use outdoors.

This dehumidifer is intended ofr indoor residential applications only. This dehumidifier should not be used for commercial or industrial applications.

Place the dehumidifier on a smooth, level floor strong enough to support the unit with a full bucket of water. Allow at least 20cm of air space on all sides of the unit for good air circulation.

Place the unit in an area where the temperature will not falll delow 5 C(41 F). The coils can become covered with frost at temperatures below 5 C(41 F), which may reduce performance.

Place the unit away from the clothes dryer, heater or radiator. Use the unit to prevent moisture damage anywhere books

40cm or more

Air intake grille

20cm or more

20cm or more

Air outlet grille

20cm or more

20cm or more

or valuables are stored.

Use the dehumidifier in a basement to help prevent moisture damage.

The dehumidifier must be operated in an enclosed area to be most effective.

Close all doors, windows and other outside openings to the room.

Fig.4

Casters(At four points on the bottom of unit)

Positioning the unit Casters can only move laterally.

When using the unit Do not force casters to move over carpet, nor move the unit with water in the bucket. (The unit may tip over and spill water.)

When using the unit

When first using the dehumidifier, operate the unit continuously 24 hours.

This unit is designed to operate with a working environment between 5 C and 35 C.

If the unit has been switched off and needs to be switched on again quickly, allow approximately three minutes for the correct operation to resume.

Do not connect the dehumidifier to a multiple socket outlet, which is also being used for other electrical appliances.

Select a suitable location, making sure you have easy access to an electrical outlet.

Plug the unit into a 115V~ 60Hz electrical socket-outlet with earth connection.

Make sure the Water bucket is correctly fitted otherwise the unit will not operate properly.

6

Page 7
Image 7
Alen MDF-70AE, MDF1-30AE, MDF-50AE manual Operating The Unit, Positioning the unit, When using the unit