Removing the collected water
There are two ways to remove collected water. 1. Use the bucket
When the bucket is full, the unit will automatically stop running, and the Full indicator light will flash.
Slowly pull out the bucket. Grip the left and right handles securely, and carefully pull out straight so water does not spill. Do not put the tank on the floor because the bottom of the bucket is uneven. Otherwise the bucket will fall and cause the water to spill.
Throw away the water and replace the bucket. The bucket must be in place and securely seated for the dehumidifier to operate.
The machine will
NOTES:
When you remove the bucket, do not touch any parts inside of the unit. Doing so may damage the product. Be sure to push the bucket gently all the way into the unit. Banging the bucket against anything or failing to push it in securely may cause the unit not to operate.
2. Continuous draining
Water can be automatically emptied into a floor drain by attaching the unit with a water hose (not included).
Remove the water bucket from the front of the unit, you will find a section of hose located above the bucket.
Remove the rubber plug from the back of the unit and store it in a safe location(see Fig.8).
Insert the water hose through the hole in the back of the unit and securely press it onto the connector on the front of the unit(see Fig.9). Then lead the water hose to the floor drain or a suitable drainage facility.
Replace the bucket in the unit. The bucket must be in place and securely seated.
NOTE: When the continuous drain feature is not being used, remove the drain hose from the connector and attach the back drain hole with the rubber plug shown in Fig.1.
CARE AND MAINTENANCE
1. Pull out the bucket a little.
Fig.5
2.Hold both sides of the bucket with even strength, and pull it out from the unit.
Fig.6
3. Pour the water out.
Fig.7
Remove the
rubber plug
Push the hose into the drain hole
Fig.8
Drain hose
Connector
Fig.9
7
