CONTROL PADS ON THE DEHUMIDIFIER
Power on | Continuous | Bucket full | High fan | Normal fan |
indicator light | operation on | indicator light | indicator | |
| indicator light | 5 | light | indicator light |
|
|
| ||
Power |
|
|
| Normal |
| Continuous |
| Turbo |
|
| C | Full |
|
|
|
| Humidity% |
|
|
1 |
|
|
| 4 |
2 |
|
|
| |
|
| 3 |
| Fig.1 |
|
|
|
|
Control pads
1POWER Pad
Press to turn the dehumidifier on and off.
2Continue Pad
Select for the dehumidifier to operate continuously for maximum dehumidification until the bucket is full. The Humdity set control pads cannot be used when Continuous operation is on.
3Humidity Set Control Pads
The humidity level can be set within a range of 35%RH(Relative Humidity) to 80%RH(Relative Humidity) in 5% increments.
For drier air, press the pad and set to a lower percent value(%).
For damper air, press the pad and set a higher percent value(%).
4Fan speed Pads
Control the fan speed. Press to select either High or Normal fan speed. Set the fan control to High for maximum moisture removal. When the humidity has been reduced and quiet operation is preferred, set the fan control to Normal.
5Display
Shows the set % humidity level while setting, then shows the actual(+5% accuracy) room % humidity level.
Error Codes:
E1- Humidity sensor
E2- Temperature sensor
P1- Unit is
P2- Bucket is
Other features
Bucket Full Light
Glows when the bucket is ready to be emptied, or when the bucket is removed or not replaced in the proper position.
Auto Shut Off
The water level control switch shuts off the dehumidifier when the bucket is full, or when the bucket is removed or not replaced in the proper position. When the setting humidity
is reached, the unit will be shut off automatically.
Auto Defrost
When frost builds up on the evaporator coils, the compressor will cycle off and the fan will continue to run until the frost disappears.
Power Outage
In the case of a power outage or interruption, the unit will automatically
4