Samsung AR18FSSEDWUNEU, AR18FSSEDWUXEU, AR09FSSEDWUXEU manual Connecting network with WPS setting

Connecting network with WPS setting

ENGLISH

2

1-2

1-1

1.After pressing the [2ndF] button on the remote controller, press the [WPS] button. message will be displayed on the front display panel of the air conditioner.

2.Press [WPS] button on the wireless router that will be connected to an air conditioner and operate the WPS function of the wireless router. (The location of WPS button may be different depending on the wireless manufacturing company.)

3. After connecting the air conditioner with the wireless router correctly, the Wi-Fi ( ) light on the Wi-Fi module will be on.

•Check whether the wireless router supports Wi-Fi Protected Setup™(WPS).

NOTE • Check whether the wireless router has WPS button.

•Samsung smart air conditioner uses PBC method of WPS.

•When searching a network by pressing [WPS] button, the remote controller will not work for a maximum of 2 minutes.

•Be careful when pressing the WPS button because if you hold the WPS button for a long time, the set value of the wireless router will be initialized with some types of wireless router.

•Operating wireless router through WPS mode might be different depending on the manufacturing company. Therefore, please refer to the user manual of your wireless router.

•If the wireless router(AP) is not authenticated with WPS, connection failure might occur.

CAUTION	• If the wireless router that is not authenticated with WPS is connected to an air conditioner, the previously
	connected Wi-Fi of other units might be disconnected.

11

Crystal WiFi APP_IB_DB68-03373A_EN.indd 11

2012-11-20 18:42:29