How to connect your extended power cables
Items to prepare
(compressor and insulation tape should be prepared by an installation technician.)
Tools | Crimping pliers | Connection sleeve (mm) | Insulation tape | Contraction tube (mm) |
Spec | 20xØ7.0(HxOD) | Width 18 mm | 50xØ8.0(LxOD) | |
Shape |
|
|
|
|
nall Inst07
1.As shown in the figure, peel off the shields from the rubber/wire of the power cable.
- Peel off 20 mm of the wire shields of the tube installed already.
• After peeling off the tube wire, you must insert a contraction tube.
(Unit: mm)
Power cable (provided by us)
20 20 20
60
120 180
Wire tube power cable
20
atio
2. | Insert both sides of core wire of the power cable into the connection sleeve. |
|
|
| Connection sleeve |
3. | Using a compressor, compress the two points and flip it over |
|
| and compress another two points in the same location. | Comp. dim. |
| ||
|
| |
| - After compressing it, pull both sides of the wire to |
|
| make sure it is firmly pressed. |
|
|
| Compress it 4 times |
4. | Wrap it with the insulation tape twice and position your | 5 mm |
| ||
| contraction tube in the middle of the insulation tape. | Insulation tape |
|
| |
5. | Apply heat to the contraction tube to contract it. |
|
|
| 40 mm |
|
| Contraction tube |
6. | After tube contraction work is completed, wrap it with the |
|
| insulation tape to finish. | Insulation tape |
|
|
• In case of extending the electric wire, please DO NOT use a
|
| 2/17/2015 2:14:31 PM | |
|
| ||
|
|
|
|