Wired Remote Controller-Buttons and Display
The wired remote controller is an optional accessory and it is installed on the wall.
Operating mode
Removing frost indicator 
(Except Cooling Only Models)
Communication error indicator 
On Timer setting
Off Timer setting
Test indicator
Temperature adjustment buttons
Centralized controller indicator
(In case of installing the Centralized controller)
Temperature setting
Fan speed
Air flow direction
Filter Sign indicator
On/Off & Timer
Set/Cancel button
On/Off indicator
On Timer button
Off Timer button
Test button
Fan speed adjustment |
button |
Swing button |
(Not operated) |
Filter Reset button |
Mode selection button
Note - Test button is for your installation specialist. You must NOT press it.
-After cleaning the air filter, press the filter reset button. Then the wired remote controller will display the FILTER SIGN indicator when the time to clean the air filter; refer to page 30 or 31.
-Duct type air conditioner does not have function of adjusting air flow direction. Therefore, the function is not operated even if you press the swing button.
-The heating mode(
) is not selected in cooling only models.
