Samsung DA99-01225E Installation Of The Water Dispenser Line, Check the water supply line, Case

INSTALLATION OF THE WATER DISPENSER LINE

Connect the water line to the refrigerator

-Slip the compression nut and plastic ferrule through the plastic tube.

-After inserting the sleeve, tighten the compression nut onto 1/4”

compression fitting(union).

			Compression Nut
	NOTE	Do not overtighten the compression nut.	Ferrule
			Sleeve
-	Slip the compression ferrule and nut on copper		Compression fitting
	(or plastic) tubing as shown.		Ferrule
	Tighten the comperssion nut onto the compres-
	sion fitting(union).		Compression Nut
-	Turn water on and check for any leakege.

NOTE Waterline must be connected to drinkable water only

(Case 2)

Check the water supply line

Connect the water pipe with coupler and tap.

-Close the main water tap.

-Connect coupler “A” to the tap.

-Every join should be protected with sealing tape.

WARRANTY INFORMATION

This water line installation is not covered by the refriger-ator or ice maker manufacturer's warranty.

Follow these instructions carefully to minimise the risk of expensive water damage.

CAUTION

The water line must be connect-ed

to the cold water pipe.

If it is connected to the hot waterpipe, it may cause the purifier to malfunction.

COUPLER “A”

Note:

If the coupler does not fit on the current tap, go the nearest authorised service dealer and purchase

the right couplers fittings.

TAP

Connect the water line to the refrigerator.

- Remove the compressor cover of the refrigerator.	WATER LINE	CONNECTION NUT
- Connect the water line to the valve, as shown in the figure.
- When connected, check if there is any leakage.
If any, repeat the connection.
- Reattach the compressor cover of the refrigerator.
		COMPRESSOR COVER OF
		REFRIGERATOR

34