INSTALLATION OF THE WATER DISPENSER LINE
Connect the water line to the refrigerator.
- Remove the compressor cover of the refrigerator. WATER LINECONNECTION NUT - Connect the water line to the valve, as shown in the figure.
- When connected, check if there is any leakage.
If any, repeat the connection. - Reattach the compressor cover of the refrigerator.
COMPRESSOR COVER
OF REFRIGERATOR
Secure the water line.
-Using clip ”A”, fix the water line to the wallor (the back of refrigerator).
-When the water line is secure, make sure whether the water line is not excessively bent, pinched or squashed.
Complete the installation of the water supply line.
-Power on the refrigerator and press the lever on the right of the
dispenser until water runs out through the water line and all air has been empty.
-At this time, check for any possible leakages at the join point in the water line. After securing the water line, move the refrigerator to the required location. Once the refrigerator is in position, do not move possibly.
CLIP A 
WATER LINE
Install the water filter.
1)Remove the fixed cap (A) as shown. the fixed cap separates from the Water Filter Compartment by rotating it counterclockwise. Remove the water filter from the box and put a month indicator
stick on the filter as shown.
Keep the cap(A) in a safe place for recapping, when you NOTE don’t need to use the filter.
2)If the water filter was installed in March, put on the "SEP" sticker.
3)Remove the Red protective cap from the filter, then position and insert the filter as shown.
4)Slowly turn the water filter clockwise 90º to align
the indication mark on the cover, locking the filter in position. Do not overtighten.
SEPARATION
OF RED CAP
STICKER
(MONTH INDICATION)
Please check that the indication line aligns with the lock position.
NOTE
(A)
COVER FILTER
ALIGN THE INDICATION MARK WITH LOCK POSITION.
INSTALLATION INSTRUCTIONS
29
