STEP 2
Removing the shipping bolts
Before using your washer, you must remove the four shipping bolts from the back of the unit.
1.Loosen all the bolts with the supplied wrench.
2.Slide the bolt and spacer up and remove the bolt with the spacer through the hole in the rear wall of your washer. Repeat for each bolt.
3.Fill the holes with the supplied bolt hole covers.
4.Keep the shipping bolts and spacers for future use.
01 SETTING UP
STEP 3
Installing your washer
1.Place the drain hose in the drain facility. Be sure an airtight connection is NOT made between the drain hose and the standpipe.
The standpipe must be at least 18in.(46 cm) high.
Caution must always be exercised to avoid collapsing or damaging the drain hose. For best results, the drain hose should not be restricted in any way – by elbows, couplings, or excessive lengths. For situations where the drain hose
cannot be conveniently elevated to at | 96” Max | |
18” Min | ||
least 18in.(46 cm), the drain hose must | ||
| ||
be supported. |
|
Hose
Guide
Laundry tub |
| Stand pipe |
| Hose |
|
| retainer |
|
|
| 96” Max |
| Tie | 18” Min |
|
| |
| strap |
|
2. Before connect the inlet hoses to water faucets, check to ensure a washer is inside coupling.
Coupling | Rubber |
| Washer |
setting up your new washing machine _15
