Samsung DCS-408, DCS-408I S

Samsung System Administration Guide

DCS-408 & 408i November 2001

System Administrator Programming

[MMC 200]

Before any customer programs can be accessed, you must first open programming

using the Customer-level passcode you have been assigned. This, and all subsequent

programming, must be done using a display keyset.

Note: Should it become necessary to change this passcode, see MMC 201.

Program Keys

VOLUME UP & DOWN - Used to scroll through options.

KEYPAD - Used to enter selections.

SPEAKER - Used to store data and advance to next program.

ACTION DISPLAY

1. Press TRSF and dial 200.

2. Dial the 4-digit passcode.

(The passcode is not displayed)

3. Dial 1 to select ‘ENABLE’

Press VOLUME UP or DOWN key to select

4. Press the SPEAKER key.

5. Dial the 3-digit program (MMC) code you want to access

(e.g. 201)

Scroll through MMC codes using the VOLUME UP or

DOWN key and press the SPEAKER key to select.

Follow the instructions for your chosen program. Selected programs are described in

this section. For other programs, refer to the Samsung DCS Combined Programming

Manual.

Note: You must begin programming within 30 seconds o f opening a program. Once you are in

programming mode, any delay of more than 30 seconds between keystrok es will cause the sys-

tem to automatically close programming. (The system timer can, however, be changed to allow

more or less time before programming m ode is closed. Ask your dealer or the system installer

for advice.)

ENABLE CUS. PROG.

PASSCODE:

ENABLE CUS. PROG.

DISABLE

ENABLE CUS. PROG.

ENABLE

201: CUS. PASSCODE

SELECT PROG ID