DTS

Dynamic Compression

If your A/V receiver is equipped with a DTS decoder, your DVD-VCR can output DTS digital sound, but you MUST enable this feature in the menu system.

NOTE: Select “On” ONLY if you have connected a DTS-equipped A/V receiver to the Digital audio Out (coaxial) on the DVD-VCR rear panel.

1Open “MENU”

Press the MENU button while the DVD is in Stop mode.

2Select “DVD”

Use the UP/DOWN buttons to highlight “DVD” then press the ENTER button.

3Select “Audio”

Highlight “Audio”, then press the ENTER button.

4Set “DTS”

Highlight “DTS” then press the RIGHT button to select one of the following options:

Off – To use your DVD/TV with an A/V receiver NOT equipped with a DTS decoder.

On – To use your DVD/TV with an A/V receiver equipped with a DTS decoder

Off

On

PCM Down Sampling

: On

Dynamic Compression restrains the dynamic range of sounds, i.e. the difference between the loud and quiet passages of a DVD audio track.

1Open “MENU”

Press the MENU button while the DVD is in Stop mode.

2Select “DVD”

Use the UP/DOWN buttons to highlight “DVD” then press the ENTER button.

3Select “Audio”

Highlight “Audio”, then press the ENTER button.

4Set “Dynamic Compression”

Highlight “Dynamic Compression”, then press the RIGHT button to select one of the following options:

On – This will compress the total dynamic range of the DVD audio, making quiet passages in the audio signal louder and loud passages softer.

Off – This will preserve the original dynamic range.

 

On

On

 

On

 

Off

PCM Down Sampling

: Offn

 

ENG-18

Page 19
Image 19
Samsung DVD-V9090 instruction manual Set DTS, Set Dynamic Compression