FACTORY & ELECTRONIC ADJUSTMENT

VER1.0

C.Select B-GAIN and adjust the B-GAIN value until y = 343±30

D.Repeat steps A, B and C until the following final values are obtained:

x= 335±30

y= 343±30

Y = 30±1 FL

(5)Upon completion of Steps 3 and 4 above, press the FAV.SET key for the next Color Temperature setting (5400→6500D→9300→13800).

For each color temperature setting, please repeat Steps 3 and 4 above but replace the x and y settings with the following values:

a.6500D: x = 313, y = 329 for both Dark and Bright Level Settings

b.9300K: x = 285, y = 295 for both Dark and Bright Level Settings

c.13800K: x = 260, y = 275 for both Dark and Bright Level Settings

For these 3 Color Temperatures (6500D, 9300K and 13800K), adjust the Dark and Bright Levels to the following Y values:

a.Dark level Y = 0.4±0.1 FL

b.Bright level Y = 30±1 FL

(6)Once all 4 Color Temperatures have been adjusted, skip through the RGB and Component Color Temperatures (using the FAV.SET key) and completely exit the Factory Adjustment Menu.

2.1Pre-setting Adjustment and Equipment Preparation for RGB Mode:

(1)Turn on the Color Analyzer (Minolta, Model = CA-100) and reset the Color Analyzer.

(2)Switch the PDP input to RGB mode and press the “Recall” key on the remote control to have the PDP set recalled back to default factory settings.

(3)Set up the Video Pattern Generator (Chroma, Model = C2226) with the following settings:

A. Timing: 640 x 480 @ 60Hz,

B. Make sure the Output signal is Analog (RGB)

Connect the PDP RGB input connector to the Chroma C-2226 RGB output connector.

(4)Dark level and bright level center block definition:

A.Dark level center block definition: Pattern set = Pattern name = 1-mosaic Color form = norm

Background color = 0 Foreground color = 17

According to the C-2226’s user manual, appendix analog-color: Normal Pen

from Pen 17 = R: 102, G: 102, B: 102

102 (output amplifier)/1024 (total amplifier)=10%, therefore the 10% is the 10 IRE white output pattern.

3-4

Page 20
Image 20
Samsung GTW-P50M603 service manual Factory & Electronic Adjustment