28_ English
INSERTING/EJECTING A MEMORY CARD
Inserting a memory card
1. Open the memory card cover by sliding the OPEN switch to the left as shown
in the figure.
2. Insert the memory card into the slot until it softly clicks.
• Make sure that the terminal portion is facing up and the camcorder is
placed as shown in the figure.
3. Close the memory card cover.
Ejecting a memory card
1. Open the memory card cover by sliding the OPEN switch to the left as shown
in the figure.
2. Slightly push the memory card inwards to pop it out.
3. Pull the memory card out of the slot and close the memory card cover.
The HD camcorder supports SD and SDHC memory cards for data storage.
The data storage speed may differ, according to the manufacturer and production system.
• SLC (single level cell) system: faster write speed enabled.
• MLC (multi level cell) system: only lower write speed is supported.
For best results, we recommend using a memory card that supports faster write speed.
Using a lower write speed memory card for recording video may cause difficulties when storing.
You may even lose your movie data during the recording.
In an attempt to preserve any bit of the recorded movie, the HD camcorder forcibly stores the movie on the memory card and
displays a warning: “Low speed card. Please record a lower Resolution.”
If you are unavoidably using a low speed memory card, resolution and quality of the recording may be lower than the set value.
pages 60-61
Actual formatted capacity may be less as the internal firmware uses a portion of the memory.