![](/images/new-backgrounds/1032127/3212741x1.webp)
5.Insert and tighten three large screws (5x15, For connecting Stand Pole & Stand Base) into the three holes on the bottom side of the
!CAUTION
When you use a torque screwdriver, be careful not to put excessive force. Otherwise, it runs idle or can be damaged. (torque screwdriver- below 15 kg.f.cm)
6.Connect the speaker wire to the speaker jack.
7.Fully insert the Stand Bracket into the speaker's clasp to stand speaker.
8.Insert and tighten two small screws (4x20, For connecting Stand Bracket & Speaker) into the two holes to connect them.
| 02 |
5 | Connections |
| |
6 |
|
7 |
8 |
9. This is the appearance after the speaker is installed. | 9 |
Follow this steps to install other speaker. |
|
|
|