Setting the Speaker Mode
Setting the Test Tone
1 Press MENU button.
In the Speaker3 Setup, press the ENTER button again.Press Cursor 2 button to move to ‘Audio’ and then
press ENTER button.
Press Cursor , ,, buttons to move 4 to the desired
speaker and then press ENTER button.1 |
| 2 | Press Cursor | 3 | Press Cursor button | |
Press MENU button. | button to move to | to move to ‘TEST | ||||
|
|
| ||||
|
| ‘Audio’ and then |
| TONE’ and then press | ||
|
|
|
| |||
|
|
| press ENTER button. |
| ENTER button. |
• The test tone will be sent to L ➝ C ➝ R ➝ RS ➝ LS ➝ SW in that order.
If the button is pressed again at this time, the test tone will stop.•For C, LS, and RS, each time the button is pressed, the mode switches alternately as follows: SMALL ➝ NONE.
•For L and R, the mode is set to SMALL.Press RETURN button to return to the previous level.
Press MENU button to exit the setup screen.
SETUP
41
SMALL : Select this when using the speakers.NONE : Select this when no speakers are installed.AC-3 and DTS, the delay time is set between 00 and 15mSEC.• Depending on PRO LOGIC and STEREO, the speaker mode may vary.
Note
• With (Dolby Pro Logic II), the delay time may be different for each mode.• WithWhen manually testing using the TEST TONE buttonPress TEST TONE button.
•Test tone will be produced as follows: When playing a DVD or CD, this will work only in Stop mode.
•Use this function to check that each speaker is correctly connected and that there is no problem.
To end the test tone, press TEST TONE button.L: Front Speaker (L) | C: Center Speaker | SW: Subwoofer |
R: Front Speaker (R) | LS: Rear Speaker (L) | RS: Rear Speaker (R) |
Start
42