Connecting External Components
Connecting an External Analog Component
Example: Analog signal components such as a VCR.
Audio Cable
(not supplied)
If the external analog compo- nent has only one Audio Out, connect either left or right.
Connecting the FM and AM Antennas | GB |
|
AM Loop Antenna (supplied)
FM Antenna (supplied)
Snap the tabs on the | CONNECTIONS |
| |
loop into the slots of the |
|
base to assemble the |
|
AM loop antenna. |
|
FM antenna connection | AM antenna connection |
1 Connect AUX (Audio) In on the Home Theater to Audio Out on the external analog compo- nent.
•Be sure to match connector colors.
2 Press AUX button on the remote control to select ‘AUX1’, ‘AUX2’ or ‘USB’.
1.Connect the FM antenna supplied to the FM 75Ω COAXIAL terminal.
2.Slowly move the antenna wire around until you find a location where reception is good, then fasten it to a wall or other rigid surface.
1.Connect the AM loop antenna supplied
to the AM and terminals.
•Insert the black wire into the black terminal and the white wire into the white terminal.
2.If reception is poor, connect an outdoor single
•You can also use the FUNCTION button on the main unit.
The mode switches as follows: DVD/CD ➝ TAPE ➝ AUX1 ➝ AUX2 ➝ USB ➝ FM ➝ AM
Note | • You can connect the Video Output jack on your VCR to the TV, and connect the Audio |
| Output jacks on the VCR to this product. |
Cooling Fan | The cooling fan supplies cool air to the unit to prevent overheating. |
Please observe the following cautions for your safety.
• Make sure the unit is
•Do not obstruct the cooling fan or ventilation holes. (If the cooling fan or ventilation holes are covered with a newspaper or cloth, heat may build up inside the unit and fire may result.)
Note | • This unit does not receive AM broadcasts. |
15 | 16 |