Samsung HT-ES6550W/TK Attaching the Toroidal Ferrite Core, For Power Cord/HDMI Cable/LAN Cable

Connections

The wireless receiving antenna is built into the wireless receiver module. Keep it away from water and moisture.

For optimal listening performance, make sure that the area around the wireless receiver module location is clear of any obstructions. If you hear no sound from the wireless surround speakers, switch the mode to Dolby Pro Logic II.

In 2-CH mode, you will hear no sound from the wireless surround speakers.

NOTE

If you place a speaker near your TV set, the screen Color may be distorted because of the magnetic field.

Place the wireless receiver module at the rear of the listening position. If the wireless receiver module is too close to the product, sound from the speakers may be disrupted because of interference.

If you use a device such as a microwave oven, wireless LAN Card, or any other device that uses the 2.4/5.8GHz frequencies near the product, sound from the speakers may be disrupted because of interference.

The maximum transmission distance from the product to the wireless receiver module is about 10m, but may vary depending on your operating environment. If a steel-concrete wall or metallic wall is between the product and the wireless receiver module, the system may not operate at all, because the radio wave cannot penetrate metal.

If the product doesn't make a wireless connection, you need to run an ID Set between the product and wireless receiver module. With the product turned off, press "0""1""3""5" on the remote control. Turn on the wireless receiver module. Then, press and hold the “ID SET” button on the back of the wireless receiver module for 5 seconds, and then turn the product on.

Attaching the Toroidal Ferrite Core

For Power Cord/HDMI Cable/LAN Cable

If you attach a Toroidal ferrite core to the power cord of the main unit, it will help to prevent RF interference from radio signals.

1.Pull the fixing tab of the Toroidal ferrite core to open it.

2.Make a loop twice in the main unit power cord.

3.Attach the toroidal ferrite core to the main unit power cord as the figure shows and press it until it clicks.

Method for connecting toroidal ferrite core to HDMI cable and LAN cable is same as steps 1-3 described above.

NOTE

Attach the ferrite core to the main unit as close as possible.

Power Cord

< In case of Power Cord >

18 English

HT-ES6550W_TK_0824.indd 18 2012-08-24 오전 11:43:10