Samsung HT-F6550W/SJ manual Networks and the Internet, Configuring Your Network Connection

	Support
	When activated, lets Samsung
	Call Centre agents diagnose and
Remote	fix problems with the product
	remotely. Requires an active Internet
Management	connection. Remote Management
	service might not be available in
	some countries.
Software	For more information about the
	Software Update function, see
Update	"Upgrading Software" on page 28.
	Lets you set the Use mode. If you
Usage Mode	are using the home cinema at home,
	always select Home. Store is for
	retail display settings only.
Contact	Provides contact information for
Samsung	assistance with your product.
	Reverts all settings to their defaults
	except for the network and Smart
Reset	Hub settings, and then starts the
	Setup function. Requires that you
	enter your security PIN. The default
	security PIN is 0000.

Networks and the Internet

When you connect this product to a network, you can use network based applications and functions such as Smart Hub and BD-LIVE, and upgrade the product's software through the network connection. For more information about accessing and using Internet services, see the Network Services chapter of this manual on pages 43~51. Instructions for configuring the network connection start below.

Configuring Your Network Connection

If you didn't configure your network connection during the initial settings procedure or you need to reset the network connection, follow the directions below.

Before you begin, contact your Internet Service Provider to find out if your IP address is static or dynamic. If it

is dynamic, and you have a wired or wireless network, we recommend using the Automatic configuration procedures described below.

If you are connecting to a wired network, connect the product to your router using a LAN cable before you start the configuration procedure.

To begin configuring your network connection, follow these steps:

1.In the Home screen, select Settings, and then press the E button.

2.Select Network, and then press the E button.

3.Select Network Settings, and then press the E button.

4.Go to the instructions for Wired networks starting below or the instructions for Wireless networks starting on page 26.

Wired Network

❑Wired – Automatic

After following Steps 1 to 3 above:

1.In the Network Settings screen, change Network type to Wired. Then, select Connect and press the E button. The product detects the wired connection, verifies the network connection and then connects to the network.

2.When it is done, highlight OK, and then press E button.

❑Wired - Manual

If you have a static IP address or the automatic procedure does not work, you'll need to set the Network Settings values manually.

After following Steps 1 to 3 above:

1.In the Network Settings screen, change Network type to Wired. Then, select Connect and press the E button.

The product searches for a network, and then displays the connection failed message.

NOTES

If it is possible to connect the home cinema to your network wirelessly, select Change Network at this point, change the Network type to Wireless, and then go to the instructions for wireless networks on page 26.

Network Settings

Wired network connection failed.	XX:XX:XX:XX:XX:XX
MAC Address
IP Address	0.	0.	0.	0
Subnet Mask	0.	0.	0.	0
Gateway	0.	0.	0.	0
DNS Server	0.	0.	0.	0

Unable to connect to the network. Try the following: check if your IP address is set correctly in IP Settings. Contact your Internet service provider for more information.

Change Network IP Settings Retry Close

2.Use the ◄► buttons to select IP Settings, and then press the E button. The IP Settings screen appears.

04 Settings

English 25