Samsung HT-P29 instruction manual Setting the Speaker Mode, Setting the Test Tone

Setting the Speaker Mode

Signal outputs and frequency responses from the speakers will automatically be adjusted according to your speaker configuration and whether certain speakers are used or not.

Setting the Test Tone ENG

Use the Test Tone feature to check the speaker connections.

In Stop mode,

1 press MENU

button.

In the Speaker

3 Setup, press the ENTER button again.

Press Cursor 2 button to move to ‘Audio’ and then

press ENTER button.

Press Cursor , ,

, buttons to move 4 to the desired

speaker and then press ENTER button.

•For C, LS, and RS, each time the button is pressed, the mode switches alternately as follows: SMALL ➝ NONE.

•For L and R, the mode is set to SMALL.

In Stop or no		Press Cursor		Press Cursor button
disc mode,		button to move to		to move to ‘TEST
1 press MENU	2	‘Audio’ and then	3	TONE’ and then press
		press ENTER button.		ENTER button.
button.

• The test tone will be sent to L ➝ C ➝ R ➝ RS ➝ LS ➝ SW in order.

If the ENTER button is pressed again at this time, the test tone will stop.

SETUP

Press RETURN button to return to the previous level.

Press MENU button to exit the setup screen.

SMALL : Select this when using the speakers.

NONE : Select this when no speakers are connected.

Note

•Depending on PRO LOGIC and STEREO settings, the speaker mode may vary (see page 55).

47

Alternate method: press the TEST TONE button on the remote.

Press TEST TONE button.

•Test tone will be produced as follows: When playing a DVD or CD, this will work only in Stop mode.

•Use this function to check that each speaker is correctly connected and that there is no problem.

To end the test tone,

press TEST TONE button again.

L: Front Speaker (L)	C: Center Speaker	SW: Subwoofer
R: Front Speaker (R)	LS: Rear Speaker (L)	RS: Rear Speaker (R)

Multi-Channel Pro Logic Mode

Start

48