Samsung HTDB760RH/EDC, HTDB760RH/ELS, HT-DB760 Setting the RRSSRear Reflecting Surround System

33P~72P(DB760)-GB 1/5/04 9:59 AM Page 52

Setting the RRSS(Rear Reflecting Surround System)

• By setting up the RRSS function just once, the speaker distance, channel level, and rear sound

reflection effect are automatically set and create an optimal listening environment.

• This function works only in DVD/CD mode.

1 Connect the RRSS Microphone to the RRSS input jack.

2 Place the RRSS Microphone at the listening position.

3	Press the RRSS
	button.

•A speaker tone will be heard once from each speaker in the order of L ➝ C ➝ R ➝ RS ➝ LS ➝ SW, and then the newly set error tone will be heard again from L ➝ R.

•An optimal listening environment will be set up automatically.

•It takes about 3 to 4 minutes to complete the RRSS setup.

Tone Output

A piano sound will be heard and the

setup will be completed.

Note

When "REMOVE MIC"

4 appears on the display, disconnect the RRSS Microphone.

•The RRSS button works as the RRSS setup function shown above if the RRSS Microphone is connected, and works as the rear sound reflection effect function if the microphone is removed.

•If you are installing the system for the first time or if you have initialized the system, "NO MEASURED DATA" will appear on the display when you press the RRSS button without connecting the RRSS Microphone.

•During the RRSS setup, the output volume of the tone is fixed and you cannot use the volume control buttons to adjust the output level.

•If you remove the RRSS Microphone during the RRSS setup, the setup will be cancelled.

•Place the front and left speakers (L/R) toward the side walls so that the rear speaker sound is reflected against the walls.

53