Setting the Speaker Mode

Signal outputs and frequency responses from the speakers will automatically be adjusted according to your speaker configuration and whether certain speakers are used or not.

In Stop mode,

1 press MENU

button.

In the Speaker3 Setup, press the ENTER button again.
Press Cursor 2 button to move to ‘Audio’ and then

press ENTER button.

Press Cursor , ,
, buttons to move 4 to the desired
speaker and then press ENTER button.

For C, LS, and RS, each time the button is pressed, the mode switches alternately as follows: SMALL › NONE.

For L and R, the mode is set to SMALL.
SMALL : Select this when using the speakers.NONE : Select this when no speakers are installed.

Note

Depending on PRO LOGIC and STEREO, the speaker mode may vary.

53