Chapter 04

Using MDC

Wake On LAN(WOL):

This feature allows you to power on the product by sending a pre-determined command from an external system to the product over a network.

Make sure the network is capable of data communication with the PC that sends the command to the product. Ensure you have a programme that can generate Wake on LAN signals.

Configuring Settings for Multi Control

MENUm→ System → Multi Control → ENTERE

Assign an individual ID to your product.

Configuring settings for Multi Control

•• ID Setup

Assign an ID to a set. (Range: 0~99)

Press ▲/▼ to select a number, and press E.

•• ID Input

Enter the ID number of the product connected to the input cable for input signal reception.

Enter the number you want using the number buttons on the remote control.

•• MDC Connection

Select a method to connect to MDC to receive the MDC signal.

--RS232C MDC

Communicates with the MDC via a RS232C MDC cable.

--RJ45 MDC

Communicates with the MDC via an RJ45 MDC cable.

――If MDC Connection is set to RJ45 MDC and the product is powered off, only the WOL function will be enabled. MDC communication will not be available. ――The WOL function is enabled only when MDC Connection is set to RJ45 MDC.

57