Setting the Speaker Mode

Signal outputs and frequency responses from the speakers will automatically be adjusted according to your speaker configuration and whether certain speakers are used or not.

 

1

In Stop mode,

 

2

Press Cursor

 

 

button to move to

 

press MENU

 

 

 

‘Audio’ and then

 

button.

 

 

 

press ENTER button.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Setting the Test Tone

ENG

 

Press the Test Tone to check the speaker connections and to adjust the speaker levels.

In Stop mode,

 

Press Cursor

 

Press Cursor button

 

button to move to

 

to move to ‘TEST

press MENU

 

 

 

‘Audio’ and then

 

TONE’ and then press
1 button.

2

3

press ENTER button.

ENTER button.

 

 

 

• The test tone will be sent to L ➝ C ➝ R ➝ SR ➝ SL ➝ SW in that order.

If the ENTER button is pressed again at this time, the test tone will stop.

In the Speaker
3 Setup, press the ENTER button again.
Press Cursor , ,
4 , buttons to move to the desired speaker and then press ENTER button.

•For C,SL, and SR, each time the button is pressed, the mode switches alternately as follows: SMALL ➝ NONE.

•For L and R, the mode is set to SMALL.

SETUP

Note

•The test tone functin is not available while HDMI AUDIO ON.

SMALL : Select this when using the speakers.

NONE : Select this when no speakers are installed.

Press RETURN button to return to the previous level.

47

Note

• Although Center CH can toggle between SMALL and NONE,it is not relevant to speaker settings be signals are distributed to FRONT L-CH and R-CH by creating a virtual Center CH.(Default setting is SMALL).

• SPEAKER SETUP ---Available only in DVD.

Press MENU/EXIT button to exit the setup screen.

48