JVC CA-MXGT91R manual Creating Your Own Sound Mode Manual Mode, To use your own sound mode

Boosts low and high frequency. Good for acoustic music.

Good for vocal music. Good for classical music.

Surround modes**:

D.CLUB: Increases resonance and bass.

HALL: Adds depth and brilliance to the sound.

STADIUM: Adds clarity and spreads the sound, like in an outdoor stadium.

SEA (Sound Effect Amplifier) modes:

ROCK:

POP:

CLASSIC:

Manual modes:

MANUAL 1/2/3:

Your individual mode stored in memory. See “Creating Your Own Sound Mode — Manual Mode.”

OFF: The sound mode is canceled. The SOUND MODE indicator goes off.

3 Adjust the SEA pattern.

1)Turn 4/ ¢to select the frequency range to adjust (LOW, MID, HIGH).

2)Press 1or Áto adjust the level (–3 to +3) of the selected frequency range.

3)Repeat steps 1) and 2) to adjust the level of the other frequency ranges.

4 Press SET/DISPLAY again.

**Surround elements are added to the SEA elements to create a being-there feeling in your room.

When one of these modes is selected, the SOUND MODE indicator lights up as —

While one of the SEA modes including manual modes (SEA elements without surround elements) is selected, the SOUND MODE indicator lights up as —

Creating Your Own Sound Mode

— Manual Mode

You can change SEA pattern to suit your preference. These changed settings can be stored in the MANUAL 1, MANUAL 2, and MANUAL 3 modes.

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

5 Turn 4/ ¢to select one of the

MANUAL 1, MANUAL 2, and MANUAL 3 modes into which you want to store the SEA pattern.

6 Press SET/DISPLAY again.

The SEA pattern you have created are stored into the MANUAL mode selected in the above step.

On the unit ONLY:

1 Select one of the preset sound modes.

•If you want to add the surround elements in your SEA pattern, select one of the surround modes (D.CLUB, HALL, or STADIUM) before starting the procedurem below. (See “Selecting the Sound Modes” on page 10.)

2 Press and hold SET/DISPLAY until “SEA CONT” appears on the display.

Current level appears.

To use your own sound mode

Select MANUAL 1, MANUAL 2, or MANUAL 3 mode when using the sound modes. See “Selecting the Sound Modes” on page 10.

When you unplug the AC power cord or if a power failure occurs

The setting will be erased in a few days. If this happens, set the manual sound modes again.

– 11 –