JVC CA-MXGT91R manual Connecting Speakers, Close the speaker terminals, AM MW/LW antenna

AM (MW/LW) antenna

	ANTENNA	Vinyl-covered wire
		(not supplied)
1	AM EXT
	AM LOOP

FM 75

COAXIAL

2

AM (MW/LW) loop antenna (supplied)

1Connect the AM (MW/LW) loop antenna to

the AM LOOP terminals as illustrated.

• If the AM (MW/LW) loop antenna wire is covered with vinyl, remove the vinyl by twisting it as shown in the diagram.

2Turn the AM (MW/LW) loop antenna until you have the best reception.

To connect an outdoor AM (MW/LW) antenna

When reception is poor, connect a single vinyl-covered wire to the AM EXT terminal and extend it horizontally. The AM (MW/LW) loop antenna must remain connected.

For better reception of both FM and AM (MW/LW)

•Make sure the antenna conductors do not touch any other terminals and connecting cords.

•Keep the antennas away from metallic parts of the unit, connecting cords, and the AC power cord.

Connecting Speakers

	1		3
		2
	Red
Speaker cords	SUBWOOFERS		Speaker cords
(red/black)			(red/black)
	RIGHT	LEFT
Black			Black
	RIGHT	LEFT
	MAIN
	SPEAKERS
	CAUTION: SPEAKER
	IMPEDANCE
	6	16
	Blue
	Speaker cords
	(blue/black)
Right speaker			Left speaker

1Open the speaker terminals on the rear of the unit.

2Insert the end of the speaker cord into the

terminal.

Match the polarity (colors) of the speaker terminals: Red

(+)to red (+) and black (–) to black (–); Blue (+) to blue

(+)and black (–) to black (–).

3Close the speaker terminals.

IMPORTANT: Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.

– 7 –