Connecting the AM (MW)/LW Aerial
The AM aerial (for long and medium waves) can be:
GB | Placed on a stable surface |
|
Fixed to the wall (you must first remove the base)
The AM aerial connector terminals are located on the rear of the system and are marked AM .
To avoid noise interference, check that the loudspeaker wires do not run close to the aerial wires.
Always keep them at least 2 inches (5 cm) away.
Connecting to an External Source
The auxiliary input can be used to take advantage of the sound quality of your
Examples: 
A television
A video disc player
A DAT or DCC cassette player
A
To connect the external source, the source must have an audio output. In addition, you need an RCA connection cable.
Connecting the FM Aerial
How to connect a COAXIAL TYPE aerial.
Connect a 75Ω antenna to the FM antenna terminal.
Plug the connector on the FM aerial supplied into the coaxial socket (75Ω ) marked FM on the rear of the system.
Follow the instructions given on Page 13 to tune into a radio station, and determine the best position for the aerial.
If reception is poor, you may need to install an outdoor aerial.
To do so, connect an outdoor FM aerial to the FM socket on the rear of the system using a 75Ω coaxial cable (not supplied).
1 | Set the system to standby mode and disconnect it and the external | |
| source from the main. | |
2 | Connect the audio cable to the rear of the | |
| Connect the... | To the connector marked... |
| Red jack | R (right) |
| White jack | L (left) |
| For optimum sound quality, do not invert the right and left channels. | |
3 | Plug the system back into the main socket and press Standby/On to | |
| switch it on. |
|
4 | Select the AUX source by pressing AUX on the front panel. | |
| Result: AUX is displayed. | |
5 | Switch the external source on. | |
6 | Adjust the volume and balance as required: | |
| Volume | Equalizer |
Example: You can watch a film and take advantage of stereo sound provided that the original sound track is in stereo, (as if you were in a cinema).
8
