INSTALLING YOUR MICROWAVE OVEN
Place the oven on a flat level surface 85 cm above the floor. The surface should be strong enough to safely bear the weight of the oven.
WHAT TO DO IF YOU ARE IN DOUBT OR HAVE A PROBLEM
If you have any of the problems listed below try the solutions given.
1.When you install your oven, make sure there is adequate ventilation for your oven by leaving at least 10 cm (4 inches) of space behind and, on the sides of the oven and 20 cm (8 inches) of space above.
20 cm | 10 cm |
above | behind |
| 10 cm on |
| the side |
This is normal.
•Condensation inside the oven
•Air flow around the door and outer casing
•Light reflection around the door and outer casing
•Steam escaping from around the door or vents
ENGLISH
2. Remove all packing materials inside the oven. Install the roller ring and turntable.
Check that the turntable rotates freely.
3.This microwave oven has to be positioned so that plug is accessible.
If the supply cord is damaged, it must be replaced by a special cord or assembly available from the manufacturer or its service agent.
For your personal safety, plug the cable into a
Do not install the microwave oven in hot or damp surroundings like next to a traditional oven or radiator. The power supply specifications of the oven must be respected and any extension cable used must be of the same standard as the power cable supplied with the oven. Wipe the interior and the door seal with a damp cloth before using your microwave oven for the first time.
The oven does not start when you turn the Time/Weight(
) dial.
•Is the door completely closed? The food is not cooked at all
•Have you set the timer correctly and/or pressed the Time/Weight
(
) dual.
•Is the door closed?
•Have you overloaded the electric circuit and caused a fuse to blow or a breaker to be triggered?
The food is either overcooked or undercooked
• Was the appropriate cooking length set for the type of food?
• Was an appropriate power level chosen?
Sparking and cracking occur inside the oven (arcing)
•Have you used a dish with metal trimmings?
•Have you left a fork or other metal utensil inside the oven?
•Is aluminum foil too close to the inside walls?
The oven causes interference with radios or televisions
• Slight interference may be observed on televisions or radios when the oven is operating. This is normal. To solve this problem, install the oven away from televisions, radios and aerials.
•If interference is detected by the oven’s microprocessor, the display may be reset. To solve this problem, disconnect the power plug and reconnect it. Reset the time.
9
ME82V_EN.indd 9 |
