Samsung ME82V-SS/XEE, ME82V-S/XEE, ME82V-WW/XEE manual ME82VEN.indd 2010-12-02

PRECAUTION TO AVOID POSSIBLE EXPOSURE TO	IMPORTANT SAFETY INSTRUCTIONS
EXCESSIVE MICROWAVE ENERGY.	Make sure that these safety precautions are obeyed at all times.
Failure to observe the following safety precautions may result in harmful	WARNING
exposure to microwave energy.
(a) Under no circumstances should any attempt be made to	Only qualified staff should be allowed to
operate the oven with the door open or to tamper with the safety
interlocks (door latches) or to insert anything into the safety	modify or repair the microwave oven.	ENGLISH
interlock holes.	containers.
(b) Do NOT place any object between the oven door and front	Do not heat liquids and other food in sealed
face or allow food or cleaner residues to accumulate on sealing
surfaces. Ensure that the door and door sealing surfaces are	For your safety, do not use high-pressure
kept clean by wiping after use first with a damp cloth and then	water cleaners or steam jet cleaners.
with a soft dry cloth.
	Do not install this appliance; near heater,
(c)Do NOT operate the oven if it is damaged until it has been
repaired by a qualified microwave service technician trained by the	inflammable material; in a humid, oily or
manufacturer. It is particularly important that the oven door closes	dusty location, in a location exposed to direct
properly and that there is no damage to the:	sunlight and water or where gas may leak;
(1) Door (bent)	on un level ground.
(2) Door hinges (broken or loose)	This appliance must be properly grounded in
(3) door seals and sealing surfaces
	accordance with local and national codes.
(d)The oven should not be adjusted or repaired by anyone other than	Remove all foreign substances such as dust
a properly qualified microwave service technician trained by the
manufacturer.	or water from the power plug terminals and
This product is a Group 2 Class B ISM equipment. The definition of group	contact points using a dry cloth on a regular
2 which contains all ISM equipment in which radio-frequency energy is	basis.
intentionally generated and/or used in the form of electromagnetic radiation	Do not pull or excessively bend or place
for the treatment of material, and EDM and arc welding equipment.
	heavy objecton the power cord.
For Class B equipment is equipment suitable for use in domestic
	In the event of a gas leak (such as propane
establishments and in establishments directly connected to a low voltage
power supply network which supplies buildings used for domestic	gas, LP gas, etc.), ventilate immediately
purposes.	without touching the power plug.
	Do not touch the power plug with wet hands.
	Do not turn the appliance off by unplugging
	the power plug while an operation is in
	progress.
	5
ME82V_EN.indd 5	2010-12-02	￿￿ 11:43:02