Where to Install Your | Connecting the Loudspeakers |
To take full advantage of your new MICRO compact system, follow GB these installation instructions before connecting the unit.
Install the system on a flat, stable surface.
Never place this unit on carpeting.
Never locate this unit in an outdoor area.
Maintain an open space of approximately 4 inches (10 cm) on the sides and rear of the system, for ventilation purposes.
Make sure that you have enough room to open the compact disc compartment easily.
Place the loudspeakers at a reasonable distance on either side of the system to ensure good stereo sound.
Direct the loudspeakers towards the listening area.
For optimum performance, make sure that both speakers are placed at an equal distance above the floor.
The loudspeaker connector terminals are located on the rear of the system (red and black tabs).
There are four terminals on the system:
Two for the left speaker (marked L)
Two for the right speaker (marked R)
To achieve the correct sound quality, connect the:
Red wire to the + terminals
Black wire to the - terminals
1To connect a wire to a terminal, push the tab as far as it will go:
To the right on the system and hold it in position
2Insert the wire, up to the plastic sheathing, in the hole.
3Push the tab back:
To the left on the system, release the tab.
Result: The wire is pinched and held firmly in place.
4Repeat the operation for each wire.
(MM-29 only)(MM-39 only)
Inserting Remote Control Batteries | Connecting Your System to the Power Supply |
Insert or replace remote control batteries when you:
Purchase the Micro compact system
Find that the remote control is no longer operating correctly
When replacing the batteries, use a new set of batteries and never mix alkaline and manganese batteries.
1Place your thumb on the position marked 
on the battery compartment cover (rear of the remote control) and push the cover in the direction of the arrow.
2Insert two AAA, LR03 or equivalent batteries, taking care to respect the polarities:
+ on the battery against + on the remote control
– on the battery against – on the remote control
3Replace the cover by sliding it back until it clicks into position.
The power cord lead must be plugged into an appropriate socket.
Before plugging your system into an outlet, you must check the voltage.
1Plug the power cord (marked AC CORD on the rear of the system) into an appropriate socket.
2Press the POWER button to switch your Micro compact system on.
4
