Viewing the Various Functions on |
| Setting the Clock |
Your System |
| |
|
|
GB
You can view the various functions available on your system.
1 Press the Demo button in standby mode.
Result: The various functions available are listed in turn on the display.
Your system is equipped with a clock which allows you to turn your system on and off automatically.
You should set the clock:
When you first purchase the micro component system
After a power failure 
After unplugging the unit
All these functions are described in detail in this booklet. For instructions on how to use them, refer to the appropriate sections.
2 To cancel this function, press Demo again.
For each step, you have a few seconds to set the required options. If you exceed this time, you must start again.
1 | Switch the system on by pressing Standby/On ( |
| ) . |
| |||
| |||
2 | Press Timer/Clock twice. |
|
|
| Result: CLOCK is displayed. |
|
|
TUNER |
|
|
| Open/Close | 3 |
|
|
|
|
| |
Band |
|
|
|
|
|
| Pervious | Tuning | Next |
| 4 |
VCD/CD | Down | Mode | Up |
| |
Down | Up | Demo/DisplayDemo | |||
|
|
|
| ||
TAPE |
| Volume |
|
|
|
AUX | REC/ec/Pause | REV.Mode | Sound | Mic | 5 |
| Mode |
| |||
|
|
|
|
| |
|
|
|
|
| 6 |
|
|
|
|
| 7 |
Press Program/Set.
Result: The hour flashes.
To...Press...
Increase the hours 
Decrease the hours 
When the correct hour is displayed, press Program/Set. Result: The minutes flash.
To...Press...
Increase the minutes 
Decrease the minutes 
When the correct time is displayed, press Program/Set.
Result: The clock starts and is displayed, even when the system is in standby mode.
You can display the time, even when you are using another function, by pressing Timer/Clock once.
You can use the |
| / |
| button on the main unit to instead | |
|
| ||||
|
| ||||
/ | button on the remote control in step 4,6. | ||||
1
2
3,5,7
4,64,6
10
