Cooking / Reheating

 

Power Levels

EN

The following procedure explains how to cook or reheat food.

ALWAYS check your cooking settings before leaving the oven unattended.

First, place the food in the centre of the turntable. Then, close the door.

1.Press the button.

Result : The 850W (maximum cooking power)

indications are displayed:

Select the appropriate power level by pressing

the button again until the corresponding wattage is displayed. Refer to the power level table.

2. Set the cooking time by Pressing the ( ) and ( ) buttons as required.

3.Press the button.

Result : The oven light comes on and the turntable starts rotating.

Cooking starts and when it has finished the oven beeps four times.

Never switch the microwave oven on when it is empty.

If you wish to heat a dish for a short period of time at maximum power(850W), simply press the +30s button once for each 30 seconds of cooking time. The oven starts immediately.

You can choose from among the power levels below.

Power Level

Output

 

 

HIGH

850 W

MEDIUM HIGH

600 W

MEDIUM

450 W

MEDIUM LOW

300 W

DEFROST

180 W

LOW / KEEP WARM

100 W

 

 

If you select the higher power level, the cooking time must be decreased.

If you select the lower power level, the cooking time must be increased.

Stopping the Cooking

You can stop cooking at any time to check the food.

1.

To stop temporarily;

 

 

Open the door.

 

 

Result :

Cooking stops. To resume cooking, close the door

 

 

and press

again.

2.To stop Completely:

Press the Stop ( ) button. Result : The cooking stops.

If you wish to cancel the cooking setting, press the Stop ( ) button again.

You can cancel any setting before you start cooking by simply pressing Stop ( ).

Adjusting the Cooking Time

You can increase the cooking time by pressing the +30s button once for each 30 seconds to be added.

Press the

button once for each 30 seconds to be added.

6

Page 6
Image 6
Samsung MW87H/BAL Cooking / Reheating Power Levels, Stopping the Cooking, Adjusting the Cooking Time, Power Level Output