Rear Panel
1 |
2 |
3 |
4 |
1.2.0 CH Speaker Connector Terminals
The speaker connector terminals are located on the rear of the system.
1.To achieve the correct sound quality, insert the speaker connector cables identified below into the correct speaker terminals on the back of the system.
•Left speaker (marked L).
•Right speaker (marked R).
2.ONLY FOR SERVICE
•This jack is for service only. Please do not use.
3.AUX IN Terminals
1.Use an Audio Cable (not supplied) to connect AUX IN on the product to Audio Out on an external analog component.
•Be sure to match connector colors.
•If the external analog component has only one Audio Out jack, connect to either the left or right terminal.
•Press the TUNER/AUX button to select the AUX input.
•When the unit is in AUX mode, if none of
the buttons are pushed for more than 8 hours, the power will automatically turn off.
4.FM Antenna Connector Terminal
1.Connect the FM antenna (supplied) to the FM Antenna jack.
2.Slowly move the antenna wire until you find a loca- tion where reception is good, then fasten it to a wall or other rigid surface.
3.If reception is poor, you may need to install an out- door antenna. To do so, connect an outdoor FM antenna to FM antenna jack on the rear of the sys- tem using a 75Ω coaxial cable (not supplied).
6 English
