installing the appliance
(Stainless steel model) | (Glass model) | 5HPRYHWKHSDQVXSSRUWVWKHEXUQHUOLGDQG | |
Sponge |
| ||
| ÀDPHVSUHDGHUDQGFDUHIXOO\WXUQWKH | ||
(A) | (C) | ||
appliance upside down and place it on a | |||
|
| ||
|
| cushioned mat. | |
(B) |
| 7DNHFDUHWKDWWKH,JQLWLRQGHYLFHVDQGÀDPH | |
(C) | supervision devices are not damaged in this | ||
|
| operation. | |
|
| 2. Apply the sponge provided around the | |
Bottom view | edge of the appliance. | ||
3. Do not leave a gap in the sealing agent or | |||
|
| ||
|
| overlap the thickness. | |
The thickness of the sponge is 1.5mm | The thickness of the sponge is 4mm | ||
(A)The width of the sponge is 11mm | (C)The width of the sponge is 10mm | ||
(B)The width of the sponge is 20mm |
|
| |
|
| 'RQRWXVHDVLOLFRQVHDODQWWRVHDOWKH | |
|
| DSSOLDQFHDJDLQVWWKHDSHUWXUH | |
|
| 7KLVZLOOPDNHLWGLI¿FXOWWRUHPRYHWKH | |
|
| DSSOLDQFHIURPWKHDSHUWXUHLQIXWXUH | |
|
| SDUWLFXODUO\LILWQHHGVWREHVHUYLFHG | |
(A) SEALING STRIP | |
(C) SCREW | (B) BRACKET |
H |
|
| H |
H |
|
| H |
3ODFHWKHEUDFNHW % RYHUWKHKROHVWKDWPDWFKWKHVL]H of the screws.There are one set of screw holes in each corner of the hob(H).
Slightly tighten a screw(C) through the bracket(B) so that the bracket is attached to the hob, but so that you can still adjust the position.
2.Carefully turn the hob back over and then gently lower it into the aperture hole that you have cut out.
3.On the underneath of the hob, adjust the brackets into a position that is suitable for your worktop.
Then fully tighten the screws(C) to secure the hob into position.
H |
|
| H |
H | H |
21_ technical instruction
